Makerbase MKS Robin Nano V1.2 3D printer motherboard control board

Friendly Reminder:

1. The motherboard's default firmware is for the Robin35 screen. If you purchased the Robin43 screen package, you will need to re-flash the firmware. The firmware can be obtained from our customer service or downloaded via GitHub.

2. The Robin43 screen does not support modifying device parameters. Device parameters can be modified via a text file.

3. The motherboard does not include a motor driver module (it is not an integrated driver motherboard). This needs to be purchased separately. If you have any questions, please consult our customer service before placing your order!

Github:

https://github.com/makerbase-mks/MKS-Robin-Nano

Robin Nano Error Types

Err1: Heated bed exceeds maximum temperature limit. Please check if the thermistor interface is short-circuited.

Err2: Nozzle exceeds maximum temperature limit. Please check if the thermistor interface is short-circuited.

Err3: Heated bed exceeds minimum temperature limit. Please check if the thermistor interface is disconnected.

Err4: Nozzle exceeds minimum temperature limit. Please check if the thermistor interface is disconnected.

Err5: Nozzle heating failure. If the nozzle does not reach the set temperature difference within the set time, an error will occur. Please check the configuration file settings or check if the power supply is sufficient.

Err6: Heated bed heating failure. If the heated bed reaches the set temperature difference within the set time, an error will occur. Please check the configuration file settings or check if the power supply is sufficient.

Err7: Thermal runaway. If, after heating to the target temperature, the current temperature falls below the target temperature value within the set time, an error will occur. Please check if the thermistor is functioning correctly or if the PID detection value is appropriate.